The air-cooled hot oil pumps produced by our company are all made of cast steel. The cast steel is made of high-strength steel containing %~% manganese, which can withstand impact and wear. It is mostly used in wear-resistant parts of mining machinery and engineering machinery for use in environments with corrosion or high temperatures above ℃. Parts that work under certain conditions, such as chemical valve bodies, pumps, containers or turbine casings of large-capacity power stations, etc. It ensures the long-term operation of the heat transfer oil pump under high-speed and high-temperature conditions. Recently, it has been found that some small private manufacturers imitate our company's heat transfer oil pump products and use ordinary pig iron castings to replace the pump body and impeller materials of the heat transfer oil pump. This is absolutely not feasible. The heat transfer oil pump itself has a very high operating temperature. Once the pig iron castings encounter There is a risk of explosion if it is cold. Therefore, the safety hazard of the pump is great. We remind all user manufacturers to pay sufficient attention, and at the same time warn some irregular manufacturers to immediately stop such unethical and dangerous behavior.
The thermal oil pump adopts a self-heating heat dissipation structure, which changes the traditional water cooling structure, making the structure simple, small in size, saving operating costs, good performance, and reliable in use. It is the second largest technology developed on the basis of our country’s digestion and absorption of foreign oil pumps. The basic structure is a single-stage single-suction cantilever foot support structure. The inlet of the pump is axial suction, and the outlet is vertically upward in the center. It is installed on the base together with the motor.
Air-cooled hot oil pump, thermal oil pump